ALL RESULTS

    • Part Name:Clutch Disc
    • Part Code:574911
    • Applicable Models:1. The Scania clutch disc is used to connect the engine and the transmission to realize the gear shift. 2. The Scania clutch disc is more wear-resisting and lasts longer.
    • Part Name:Scania Clutch
    • Part Code:2082082
    • Applicable Models:1. The Scania clutch control device is a full-automatic intelligent gear control system, which controls the clutch slave pump in an electrical way. 2. The vehicle has no clutch pedal because The Scania clutch control device is an intelligent gear system.
    • Part Name:Bus Transmission Clutch Shifting Fork
    • Part Code:1096302145
    • Applicable Models:1. The shifting fork is made of 40Cr steel, and the head is dealt with high-frequency quenching to increase its hardness. The shifting fork has an angle of 40 degree or so. 2. The back plane of the shifting fork is marked with the part number and the pla
    • Part Name:Bearing
    • Part Code:06.31421.4603-6313
    • Applicable Models:1. The bearing is installed on the main shaft of the middle axle input end and adjacent to the input oil seal to support the interaxle differential assembly. 2. The outer ring of the bearing is marked with the manufacturer's logo and the bearing model.
    • Part Name:Bus Transmission Clutch Shifting Fork
    • Part Code:1096302109
    • Applicable Models:1. The shifting fork is made of 40Cr steel, and the head is dealt with high-frequency quenching to increase its hardness. The shifting fork has an angle of 10 degree or so. 2. The back plane of the shifting fork is marked with the part number and the pla
    • Part Name:Bus Transmission Fork Bar Rocker
    • Part Code:1085302051
    • Applicable Models:It is made of 45 steel, the inner hole has fine teeth, the top is equipped with two M12 holes, and the center distance between the big hole and the small hole is 90-120mm.
    • Part Name:Bus Transmission Fork Bar Rocker
    • Part Code:1085302049
    • Applicable Models:It is made of 45 steel, the inner hole has fine teeth, the top is equipped with two M10 holes, and the center distance between the big hole and the small hole is 90-110mm.
    • Part Name:Bus Transmission Fork Bar Rocker
    • Part Code:1085302050
    • Applicable Models:It is made of 45 steel, the inner hole has fine teeth, the top is equipped with two M12 holes, and the center distance between the big hole and the small hole is 90-110mm.

Copyright Beijing Dexing Zhida Trade Co.,Ltd. All rights reserved.

Beijing ICP record 15016163-4

Technical Support: Beijing Dexing Zhida Trade Co.,Ltd.